Dell PowerConnect 6224 - Page 109

Command Groups 109
maximum-paths Sets the number of paths that OSPF can report
for a given destination.
ROSV3
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSV3
redistribute Configures the OSPFv3 protocol to allow
redistribution of routes from the specified source
protocol/routers.
ROSV3
router-id Sets a 4-digit dotted-decimal number uniquely
identifying the Router OSPF ID.
ROSV3
show ipv6 ospf Displays information relevant to the OSPF
router.
PE
show ipv6 ospf abr Displays the internal OSPFv3 routes to reach
Area Border Routers (ABR).
PE
show ipv6 ospf area Displays information about the area. PE
show ipv6 ospf asbr Displays the internal OSPFv3 routes to reach
Autonomous System Boundary Routes (ASBR).
PE
show ipv6 ospf database Displays information about the link state
database when OSPFv3 is enabled.
PE
show ipv6 ospf database
database-summary
Displays the number of each type of LSA in the
database and the total number of LSAs in the
database.
PE
show ipv6 ospf interface Displays the information for the IFO object or
virtual interface tables.
PE
show ipv6 ospf interface
brief
Displays brief information for the IFO object or
virtual interface tables.
PE
show ipv6 ospf interface
stats
Displays the statistics for a specific interface. UE
show ipv6 ospf interface
vlan
Displays OSPFv3 configuration and status
information for a specific vlan
PE
show ipv6 ospf neighbor Displays information about OSPF neighbors. PE
show ipv6 ospf range Displays information about the area ranges for
the specified area identifier.
PE
Command Description Mode*