272 Dynamic ARP Inspection Commands
arp access-list
Use the arp access-list command to create an ARP ACL. It will place the user
in ARP ACL Configuration mode. Use the “no” form of this command to
delete an ARP ACL.
Syntax
arp access-list
acl-name
no arp access-list
acl-name
•
acl-name
— A valid ARP ACL name (Range: 1–31 characters).
Default Configuration
There are no ARP ACLs created by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#arp access-list tier1
clear counters ip arp inspection
Use the clear counters ip arp inspection command to reset the statistics for
Dynamic ARP Inspection on all VLANs.
Syntax
clear counters ip arp inspection
Default Configuration
There is no default configuration for this command.
To Next Page
Loading...
