Dynamic ARP Inspection Commands 273
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#clear counters ip arp inspection
ip arp inspection filter
Use the ip arp inspection filter command to configure the ARP ACL to be
used for a single VLAN or a range of VLANs to filter invalid ARP packets. If
the static keyword is given, packets that do not match a permit statement are
dropped without consulting the DHCP snooping bindings. Use the “no” form
of this command to unconfigure the ARP ACL.
Syntax
ip arp inspection filter
acl-name
vlan
vlan-range
[static]
no ip arp inspection filter
acl-name
vlan
vlan-range
[static]
•
acl-name
—The name of a valid ARP ACL. (Range: 1–31 characters)
•
vlan-range
—A valid VLAN range.
Default Configuration
No ARP ACL is configured.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
