278 Dynamic ARP Inspection Commands
Default Configuration
There are no ARP ACL rules created by default.
Command Mode
ARP Access-list Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config-arp-access-list)#permit ip host
1.1.1.1 mac host 00:01:02:03:04:05
show arp access-list
Use the show arp access-list command to display the configured ARP ACLs
with the rules. Giving an ARP ACL name as the argument would display only
the rules in that ARP ACL.
Syntax
show arp access-list [
acl-name
]
acl-name
— A valid ARP ACL name (Range: 1–31 characters).
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
There are no user guidelines for this command.
Example
console#show arp access-list
To Next Page
Loading...
