372 IPv6 Access List Commands
console(Config-ipv6-acl)#deny ipv6 2001:DB8::/32 any
eq http
console(Config-ipv6-acl)#permit ipv6 2001:DB8::/32
any
console(Config-ipv6-acl)#
ipv6 access-list
The ipv6 access-list command creates an IPv6 Access Control List (ACL)
consisting of classification fields defined for the IP header of an IPv6 frame.
The <name> parameter is a case-sensitive alphanumeric string from 1 to 31
characters uniquely identifying the IPv6 access list.
If an IPv6 ACL with this name already exists, this command enters Ipv6-
Access-List config mode to update the existing IPv6 ACL.
Use the “no” form of the command to delete an IPv6 ACL from the system.
Syntax
ipv6 access-list
name
no ipv6 access-list
name
•
name
— Alphanumeric string of 1 to 31 characters uniquely identifying
the IPv6 access list.
Default Configuration
There is no default configuration for this command.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
The following example creates an IPv6 ACL named "DELL_IP6" and enters
the IPv6-Access-List Config mode:
To Next Page
Loading...
