IPv6 Access List Commands 373
console(config)#ipv6 access-list DELL_IP6
console(Config-ipv6-acl)#
ipv6 access-list rename
The ipv6 access-list rename command changes the name of an IPv6 Access
Control List (ACL). This command fails if an IPv6 ACL with the new name
already exists.
Syntax
ipv6 access-list rename
name newname
•
name
— the name of an existing IPv6 ACL.
•
newname
— alphanumeric string from 1 to 31 characters uniquely
identifying the IPv6 access list.
Default Configuration
There is no default configuration for this command.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config)#ipv6 access-list rename DELL_IP6
DELL_IP6_NEW_NAME
ipv6 traffic-filter
The ipv6 traffic-filter command either attaches a specific IPv6 Access
Control List (ACL) to an interface or associates it with a VLAN ID in a given
direction.
To Next Page
Loading...
