472 QoS Commands
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds to the specified class definition a match
condition based on the source MAC address of the packet.
console(config-classmap)# match source-address mac
10:10:10:10:10:10 11:11:11:11:11:11
match srcip
Use the match srcip command in Class-Map Configuration mode to add to
the specified class definition a match condition based on the source IP
address of a packet.
Syntax
match srcip
ipaddr
ipmask
•
ipaddr
— Specifies a valid IP address.
•
ipmask
— Specifies a valid IP address bit mask. Note that although this IP
address bit mask is similar to a subnet mask, it does not need to be
contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
