QoS Commands 473
Example
The following example displays adding a match condition for the specified IP
address and address bit mask.
console(config-classmap)#match srcip 10.240.1.1
10.240.0.0
match srcip6
The match srcip6 command adds to the specified class definition a match
condition based on the source IPv6 address of a packet.
Syntax
match srcip6
source-ipv6-prefix/prefix-length
•
source-ipv6-prefix
—IPv6 prefix in IPv6 global address format.
•
prefix-length
—IPv6 prefix length value.
Default Configuration
There is no default configuration for this command.
Command Mode
Ipv6-Class-Map Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-classmap)#match srcip6 2001:DB8::/32
match srcl4port
Use the match srcl4port command in Class-Map Configuration mode to add
to the specified class definition a match condition based on the source layer 4
port of a packet using a single keyword or a numeric notation.
To Next Page
Loading...
