TACACS+ Commands 569
tacacs-server host
Use the tacacs-server host command in Global Configuration mode to
configure a TACACS+ server. This command enters into the TACACS+
configuration mode. To delete the specified hostname or IP address, use the
no form of this command.
Syntax
tacacs-server host {
ip-address
|
hostname
}
no tacacs-server host {
ip-address
|
hostname
}
•
ip-address
—
The IP address of the TACACS+ server.
•
hostname —
The hostname of the TACACS+ server. (Range: 1-255
characters).
Default Configuration
No TACACS+ host is specified.
Command Mode
Global Configuration mode
User Guidelines
To specify multiple hosts, multiple tacacs-server host commands can be used.
Example
The following example specifies a TACACS+ host.
console(config)#tacacs-server host 172.16.1.1
console(tacacs)#
tacacs-server key
Use the tacacs-server key command in Global Configuration mode to set the
authentication and encryption key for all TACACS+ communications
between the switch and the TACACS+ daemon. To disable the key, use the
no form of this command.
To Next Page
Loading...
