Dell PowerConnect 6224 - Page 804

804 IPv6 Routing Commands
Example
console#show ipv6 mld-proxy groups
Interface................................ vlan 10
Group Address Last Reporter Up Time Member State Filter
Mode Sources
------------- -------------- ---------- ----------------- ---------
--- -------
FF1E::1 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude
2
FF1E::2 FE80::100:2.3 00:02:40 DELAY_MEMBER Include
1
FF1E::3 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude
0
FF1E::4 FE80::100:2.3 00:02:44 DELAY_MEMBER Include
4
show ipv6 mld-proxy groups detail
Use the show ipv6 mld-proxy groups detail command to display information
about multicast groups that MLD Proxy reported.
Syntax
show ipv6 mld-proxy groups detail
Default Configuration
There is no default configuration for this command.
Member State Possible values are:
• Idle_Member—The interface has responded to the latest group
membership query for this group.
• Delay_Member—The interface is going to send a group
membership report to respond to a group membership query for
this group.
Filter Mode Possible values are Include or Exclude.
Sources The number of sources attached to the multicast group.