IPv6 Routing Commands 803
Version........................................ 3
Num of Multicast Groups........................ 0
Unsolicited Report Interval.................... 1
Querier IP Address on Proxy Interface..........
fe80::1:2:5
Older Version 1 Querier Timeout................
00:00:00
Proxy Start Frequency...........................1
show ipv6 mld-proxy groups
Use the show ipv6 mld-proxy groups command to display information about
multicast groups that the MLD Proxy reported.
Syntax
show ipv6 mld-proxy groups
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
The following parameters are displayed by this command:
Interface The MLD Proxy interface.
Group Address The IP address of the multicast group.
Last Reporter The IP address of the host that last sent a membership report for the
current group on the network attached to the MLD-Proxy interface
(upstream interface).
Up Time (in
secs)
The time elapsed in seconds since last created.
To Next Page
Loading...
