Dell PowerConnect 6224 - Page 846

846 Multicast Commands
Example
The following example displays the multicast configuration settings such as
flags, timer settings, incoming and outgoing interfaces.
console#show ip mcast mroute group 224.5.5.5 summary
Multicast Route Table Summary
Incoming Outgoin
g
Source IP Group
IP Protocol Interface Interface List
--------- --------------- --------- --------- -------
---------
console#show ip mcast mroute group 224.5.5.5 detail
Multicast Route Table
Expiry Up Time
Source Ip Group Ip Time(secs) (secs) RPF
Neighbor Flags
--------- --------- ----------- --------- -----------
---- -----
show ip mcast mroute source
Use the show ip mcast mroute source command in Privileged EXEC mode to
display the multicast configuration settings such as flags, timer settings,
incoming and outgoing interfaces, RPF neighboring routers, and expiration
times of all the entries in the multicast mroute table containing the
sourceipaddr or sourceipaddr | groupipaddr pair value(s).
Syntax
show ip mcast mroute source sourceipaddr {summary | groupipaddr }
• sourceipaddr — IP address of source.
•
groupipaddr — IP address of multicast group.