Tektronix MSO58 User Manual

Command groups
Table 2-31: Measurement commands (cont.)
Command
Description
MEASUrement:MEAS<x>:EDGES:
UPPERFREQuency
This command sets or queries the upper frequency for the measurement when the
measurement type is phase noise. H igher frequencies are ignored.
MEASUrement:MEAS<x>:FILTe rs:
BLANKingtime
This command sets or queries the filter blanking time for the measurement.
MEASUrement:MEAS<x>:FILTers:GLOBal This command sets or queries the global flag for filter settings for the measurement.
MEASUrement:MEAS<x>:FILTers:HIGHPass:
FREQ
This command sets or queries the high pass filter frequency for the measurement.
MEASUrement:MEAS<x>:FILTers:HIGHPass:
SPEC
This command sets or queries the high pass filter order for the measurement.
MEASUrement:MEAS<x>:FILTers:LO WPass:
FREQ
This command sets or queries the low pass filter cutoff frequency for the measurement.
MEASUrement:MEAS<x>:FILTers:LO WPass:
SPEC
This command sets or queries the low pass filter order for the measurement.
MEASUrement:MEAS<x>:FILTers:RAMPtime This command sets or queries the filter ramp time for the measurement.
MEASUrement:MEAS<x>:FROMedge This command sets or queries the 'from edge' type for the measurement.
MEASUrement:MEAS<x>:
FROMEDGESEARCHDIRect
This command sets or queries the 'from edge' search direction for the measurement.
MEASUrement:MEAS<x>:GATing This command sets or queries the gating type for the measurement.
MEASUrement:MEAS<x>:GATing:ACTive
This command sets or queries the gating active level when the gating type is logic.
MEASUrement:MEAS<x>:GATing:GLOBal This command sets or queries the gating s ettings global flag.
MEASUrement:MEAS<x>:GATing:HYSTeresis
This command sets or queries the gating hysteresis v alue when the gating type is
logic.
MEASUrement:MEAS<x>:GATing:
LOGICSource
This command sets or queries the gating data source when the gating type is logic.
MEASUrement:MEAS<x>:GATing:MIDRef This command sets or queries the gating mid ref value when the gating type is logic.
MEASUrement:MEAS<x>:GATing:
SEARCHSource
This command sets or queries the gating search source when the gating type is
search.
MEASUrement:MEAS<x>:GLOBalref This command sets or queries the reference levels global flag for the measurement.
MEASUrement:MEAS<x>:HIGHREFVoltage This command sets or queries the high reference voltage value for the 'time outside
level' measurement.
MEASUrement:MEAS<x>:IDLETime This command sets or queries the idle time for the measurement when the
measurement type is burst width.
MEASUrement:MEAS<x>:JITTERSummary:
DCD
This command sets or queries whether DCD is included in the jitter summary for
the measurement.
MEASUrement:MEAS<x>:JITTERSummary:
DDJ
This command sets or queries w hether DDJ is included in the jitter summary for
the measurement.
2-46 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English