Perface
Added the note to refer to datasheets for supported peripheral functions.
The Target Products in This Manual
Modified part numbers in Table 3, 5, 6 to 8 digits description.
Modified part numbers in Table 4 to 9 digits description.
CHAPTER 6: Low Power Consumption Mode
1. Overview of Low Power Consumption Mode
5.1 Operation in Deep Standby RTC Mode
5.2 Operation in Deep Standby Stop Mode
Fixed incorrect descriptions about powered-off areas during the deep standby RTC/Stop
modes.
CHAPTER 11: DSTC
3.1.3 Specify ing OuterReload
Fixed a typo in Table 3-3.
CHAPTER 11: DSTC
4.6 Examples of Controlling DSTC
Added a description of procedure to break off a Hardware Transfer of DSTC.
CHAPTER 12: I/O Port
4.19 Extended Pin Function Setting Register 11 (EPFR11)
Removed UERLC bit in EPFR11 register.
CHAPTER 12: I/O Port
4.31 Extended Pin Function Setting Register 23 (EPFR23)
Fixed typos in descriptions of bit SCS60E, SCS61E, SCS62E, SCS63E
MFS ch7 → ch6
CHAPTER 14: External Bus Interface
Fixed function description of MNCLE signal
Chip enable → Command latch enable
CHAPTER 15: SD Card Interface
2.46 Card Detect Setting Register
Fixed incorrect division ratio of SDCLK for Card Detect Debounce Time
To Previous Page
Loading...
