Cypress FM4 Series - Write (Auto Program) Access

CHAPTER 14: External Bus Interface
FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E 771
3.3.2 Write (Auto Program) Access
Figure 3-7 shows the flowchart of the write (auto program) access.
Figure 3-7 Write (Auto Program) Access Flowchart

MNCLE is asserted/de-asserted.
Issue a write command 0x80  (Base+0x1000)
Issue an address  (Base+0x2000)
Clear MNALE (optional value)  (Base+0x3000)
End write (Auto Program)
Turn NAND mode ON
Status read  (Base+0x0000)
Status = OK?
Issue a page program command 0x10  (Base+0x1000)
Issue a status read command 0x70  (Base+0x1000)

The corresponding chip select signal is fixed to L.

MNALE is asserted.

MNALEP is de-asserted.

Accesses to other devices (SRAM) are available
during this period (a few s)
No
Yes
Single page data write  (Base+0x0000)