Cypress FM4 Series - Normal Interrupt Signal Enable Register

CHAPTER 15: SD Card Interface
866 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
2.21 Normal Interrupt Signal Enable Register
This register is used to select which interrupt status is indicate to the Host System as the interrupt.
D15
D14
D13
D12
D11
D10
D09
D08
D07
D06
D05
D04
D03
D02
D01
D00
Fixed to 0
Rsvd
Re-Tuning Event Signal
Enable
INT_C Signal Enable
INT_B Signal Enable
INT_A Signal Enable
Card Interrupt Signal
Enable
Card Removal Signal
Enable
Card Insertion Signal
Enable
Buffer Read
Ready Signal
Enable
Buffer Write Ready Signal
Enable
DMA Interrupt
Signal
Enable
Block Gap Event Signal
Enable
Transfer Complete Signal
Enable
Command Complete Signal
Enable
For details of this register, refer to SD Specifications Part A2.