Cypress FM4 Series - Initial Value Register (CRCINIT)

CHAPTER 13: CRC (Cyclic Redundancy Check)
752 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
3.2 Initial Value Register (CRCINIT)
The Initial Value Register (CRCINIT) is used to save the initial values for CRC calculation.
bit
31
0
Field
D[31:0]
Attribute
R/W
Initial value
0xFFFFFFFF
[bit31:0] D[31:0] : Initial value bits
These bits are used to save the initial values for CRC calculation.
Write the initial values for CRC calculation to this register.
(0xFFFFFFFF at resetting)
In CRC16 mode, D15 to D0 are used while D31 to D16 are ignored.