Cypress FM4 Series - Power Switching Interrupt Signal Enable Register

CHAPTER 15: SD Card Interface
898 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
2.41 Power Switching Interrupt Signal Enable Register
This register enables the generation of interrupts caused by the1ms Wait Interrupt bit and the 5ms Wait
Interrupt bit in the Power Switching Interrupt Status Register.
D31 D16
Rsvd
D15 D02
D01
D00
Rsvd
1ms Wait Interrupt Signal
Enable
5ms Wait Interrupt Signal
Enable
*: This Family does not support power switching.
Bit
Attribute
Description
31-02
Rsvd
Reserved
01
RW
1ms Wait Interrupt Signal Enable
This bit enables the generation of the interrupt caused by the 1ms Wait Interrupt bit in the
Power Switching Interrupt Status Register.
0: Disables the generation of the interrupt caused by the 1ms Wait Interrupt bit.
1: Enables the generation of the interrupt caused by the 1ms Wait Interrupt bit.
Set/Reset
Condition
Set
1 Write
Reset (0)
System reset
Software Reset For All
0 Write
00
RW
5ms Wait Interrupt Signal Enable
This bit enables the generation of the interrupt caused by the 5ms Wait Interrupt bit in the
Power Switching Interrupt Status Register.
0: Disables the generation of the interrupt caused by the 5ms Wait Interrupt bit
1: Enables the generation of the interrupt caused by the 5ms Wait Interrupt bit
Set/Reset
Condition
Set
1 Write
Reset (0)
System reset
Software Reset For All
0 Write