Cypress FM4 Series - Normal Interrupt Status Enable Register

CHAPTER 15: SD Card Interface
864 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
2.19 Normal Interrupt Status Enable Register
Setting a status enable bit in this register to 1 enables the interrupt status corresponding to that bit.
D15
D14
D13
D12
D11
D10
D09
D08
D07
D06
D05
D04
D03
D02
D01
D00
Fixed to 0
Rsvd
Re-Tuning Event Status
Enable
INT_C Status Enable
INT_B
Status Enable
INT_A Status Enable
Card Interrupt Status
Enable
Card Removal Status
Enable
Card Insertion Status
Enable
Buffer Read Ready Status
Enable
Buffer Write Ready Status
Enable
DMA Interrupt Status
Enable
Block Gap Event Status
Enable
Transfer Compl
ete Status
Enable
Command Complete Status
Enable
For details of this register, refer to SD Specifications Part A2.