CHAPTER 15: SD Card Interface
890 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
2.37 Tuning Setting Register
This register controls the settings for tuning.
Data Timeout Counter Value
For Auto Re-Tuning
CMD Conflict Check
Disable
Tuning Error Border Select
Tuning Phase Select
Enable
*: This Family does not support tuning or re-tuning.
Data Timeout Counter Value For Auto Re-Tuning
In Re-Tuning Mode 3, this field sets the data timeout counter value used in automatic
re-tuning (re-tuning by CMD19) triggered by a request trigger from SD_RT_REQ_I.
Details of this field are the same as those of Data Timeout Counter Value in the Timeout
Control Register.
System reset
Software Reset For All
0 Write
To Next Page
Loading...
