Cypress FM4 Series - Low-Speed CR Prescaler Control Register (LCR_PRSLD)

CHAPTER 2-4: Low-Speed CR Prescaler
138 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
4.1 Low-speed CR Prescaler Control Register (LCR_PRSLD)
The Low-speed CR Prescaler Control Register is used to set the division ratio of low-speed CR.
bit
7
6
5
4
3
2
1
0
Field
Reserved
LCR_PRSLD[5:0]
Attribute
-
R/W
Initial Value
00
000000
[bit7:6] Reserved: Reserved bits
Always 0 is read.
They have no effect in write mode.
[bit5:0] LCR_PRSLD: Low-speed CR Prescaler Load
At writing, sets the division ratio of the Low-speed CR Prescaler (the reload value of a reload counter) .
At reading, the set value is read.
Note:
− This register is not initialized with software reset.