Cypress FM4 Series - Force Event Register for Error Interrupt Status

CHAPTER 15: SD Card Interface
876 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
2.28 Force Event Register for Error Interrupt Status
The Force Event Register for Error Interrupt Status is not a physically implemented register, but is an
address to which the settings of the Error Interrupt Status Register can be written.
D15
D14
D13
D12
D11
D10
D09
D08
D07
D06
D05
D04
D03
D02
D01
D00
Rsvd
Force Event for AHB Master
Error
Force Event for Auto CMD19
Error
Force Event for
Boot
Acknowledge Error
Rsvd
Force Event for Tuning Error
Force Event for ADMA Error
Force Event for Auto CMD12
Error
Force Event for Current limit
Error
Force Event for Data End Bit
Error
Force Event for
Data CRC
Error
Force Event for Data Timeout
Error
Force Event for Command
Index Error
Force Event for Command
End Bit Error
Force Event for Command
CRC Error
Force Event for Command
Timeout Error
Bit
Attribute
Description
15
Rsvd
There is no Force Event for Vendor Specific Error Status bit.
14
WO
Force Event for AHB Master Error
This bit selects whether the AHB Master Error bit in the Error Interrupt Status Register is
forced to become 1.
1: An interrupt is generated.
0: No interrupt is generated.
Set/Reset
Condition
Set
1 Write
Reset (0)
System reset
Software Reset For All
0 Write
13
WO
Force Event for Auto CMD19 Error
This bit selects whether the Auto CMD19 Error bit in the Error Interrupt Status Register is
forced to become 1.
1: An interrupt is generated.
0: No interrupt is generated.
Set/Reset
Condition
Set
1 Write
Reset (0)
System reset
Software Reset For All
0 Write