Cypress FM4 Series - Error Interrupt Status Enable Register

CHAPTER 15: SD Card Interface
FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E 865
2.20 Error Interrupt Status Enable Register
Setting a status enable bit in this register to 1 enables the interrupt status corresponding to that bit.
D15
D14
D13
D12
D11
D10
D09
D08
D07
D06
D05
D04
D03
D02
D01
D00
Rsvd
AHB Master Error Status
Enable
Auto CMD19 Error Status
Enable
Boot Acknowledge Error
Status Enable
Rsvd
Tuning Error Status Enable
ADMA Error Status Enable
Auto CMD Error Status
Enable
Current
limit Error Status
Enable
Data End Bit Error Status
Enable
Data CRC Error Status
Enable
Data Timeout Error Status
Enable
Command Index Error
Status Enable
Command End Bit Error
Status Enable
Command CRC Error
Status Enable
Command Timeout Error
Status Enable
Bit
Attribute
Description
15
Rsvd
There is no Vendor Specific Error Status Enable bit.
14
RW
AHB Master Error Status Enable
This bit enables the detection of the AHB master error by the AHB Master Error bit in the
Error Interrupt Status Register.
1: Enabled
0: Masked
Set/Reset
Condition
Set
1 Write
Reset ("0")
System reset
Software Reset For All
0 Write
13
RW
Auto CMD19 Error Status Enable
This bit enables the detection of the Auto CMD19 error by the Auto CMD19 Error bit in the
Error Interrupt Status Register.
1: Enabled
0: Masked
Set/Reset
Condition
Set
1 Write
Reset (0)
System reset
Software Reset For All
0 Write
12
RW
Boot Acknowledge Error Status Enable
This bit enables the detection of the boot acknowledge error by the Boot Acknowledge
Error bit in the Error Interrupt Status Register.
1: Enabled
0: Masked
Set/Reset
Condition
Set
1 Write
Reset (0)
System reset
Software Reset For All
0 Write
For other details of this register, refer to SD Specifications Part A2.