Cypress FM4 Series - Page 426

CHAPTER 8: Interrupts
426 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
[bit4] PCRCDINT
Value
Description
0
There is no DSTC transfer end interrupt of Programmable CRC.
1
An interrupt request of DSTC transfer end interrupt of Programmable CRC has been made.
[bit3:2] QSPIDINT
bit
Value
Description
1
0
There is no DSTC transfer end interrupt of Hi-Speed Quad SPI(data
transmission).
1
An interrupt request of DSTC transfer end interrupt of Hi-Speed Quad SPI(data
transmission) has been made.
0
0
There is no DSTC transfer end interrupt of Hi-Speed Quad SPI(reception).
1
An interrupt request of DSTC transfer end interrupt of Hi-Speed Quad
SPI(reception) has been made.
[bit1:0] I2SDINT
bit
Value
Description
1
0
There is no DSTC transfer end interrupt of I
2
S ch.0 (data transmission).
1
An interrupt request of DSTC transfer end interrupt of I
2
S ch.0 (transmission) has
been made.
0
0
There is no DSTC transfer end interrupt of I
2
S ch.0 (data reception).
1
An interrupt request of DSTC transfer end interrupt of I
2
S ch.0 (data reception)
has been made.