CHAPTER 12: I/O Port
FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E 619
[bit5:4] RTO12E: RTO12 Output Select bits
Selects output for RTO12.
Reads out the register value.
Does not produce output for the waveform generator RTO12. [Initial value]
Uses RTO12_0 at the output pin of the waveform generator RTO12.
Uses RTO12_1 at the output pin of the waveform generator RTO12.
[bit3:2] RTO11E: RTO11 Output Select bits
Selects output for RTO11.
Reads out the register value.
Does not produce output for the waveform generator RTO11. [Initial value]
Uses RTO11_0 at the output pin of the waveform generator RTO11.
Uses RTO11_1 at the output pin of the waveform generator RTO11.
[bit1:0] RTO10E: RTO10 Output Select bits
Selects output for RTO10.
Reads out the register value.
Does not produce output for the waveform generator RTO10. [Initial value]
Uses RTO10_0 at the output pin of the waveform generator RTO10.
Uses RTO10_1 at the output pin of the waveform generator RTO10.
Note:
− This register is not initialized by deep standby transition reset.
To Next Page
Loading...
