CHAPTER 12: I/O Port
644 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
[bit3:2] CTS4S: CTS4 Input Select bits
Selects input for CTS4.
Reads out the register value.
Uses CTS4_0 at the input pin of MFS ch.4 CTS. [Initial value]
Uses CTS4_1 at the input pin of MFS ch.4 CTS.
Uses CTS4_2 at the input pin of MFS ch.4 CTS.
[bit1:0] RTS4E: RTS4 Output Select bits
Selects output for RTS4.
Reads out the register value.
Does not produce output for MFS ch.4 RTS. [Initial value]
Uses RTS4_0 at the output pin of MFS ch.4 RTS.
Uses RTS4_1 at the output pin of MFS ch.4 RTS.
Uses RTS4_2 at the output pin of MFS ch.4 RTS.
Note:
− This register is not initialized by deep standby transition reset.
To Next Page
Loading...
