Cypress FM4 Series - Page 647

CHAPTER 12: I/O Port
FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E 647
[bit19:16] ADTRG1S: ADTRG1 Input Select bits
Selects input for ADTRG1.
bit
Description
Reading
Reads out the register value.
Writing
0000
Uses ADTG_0 at the input pin of ADC unit 1’s startup trigger. [Initial value]
0001
Same as Writing 0000.
0010
Uses ADTG_1 at the input pin of ADC unit 1’s startup trigger.
0011
Uses ADTG_2 at the input pin of ADC unit 1’s startup trigger.
0100
Uses ADTG_3 at the input pin of ADC unit 1’s startup trigger.
0101
Uses ADTG_4 at the input pin of ADC unit 1’s startup trigger.
0110
Uses ADTG_5 at the input pin of ADC unit 1’s startup trigger.
0111
Uses ADTG_6 at the input pin of ADC unit 1’s startup trigger.
1000
Uses ADTG_7 at the input pin of ADC unit 1’s startup trigger.
1001
Uses ADTG_8 at the input pin of ADC unit 1’s startup trigger.
Writing other data
Setting is prohibited.
[bit15:12] ADTRG0S: ADTRG0 Input Select bits
Selects input for ADTRG0.
bit
Description
Reading
Reads out the register value.
Writing
0000
Uses ADTG_0 at the input pin of ADC unit 0’s startup trigger. [Initial value]
0001
Same as Writing 0000.
0010
Uses ADTG_1 at the input pin of ADC unit 0’s startup trigger.
0011
Uses ADTG_2 at the input pin of ADC unit 0’s startup trigger.
0100
Uses ADTG_3 at the input pin of ADC unit 0’s startup trigger.
0101
Uses ADTG_4 at the input pin of ADC unit 0’s startup trigger.
0110
Uses ADTG_5 at the input pin of ADC unit 0’s startup trigger.
0111
Uses ADTG_6 at the input pin of ADC unit 0’s startup trigger.
1000
Uses ADTG_7 at the input pin of ADC unit 0’s startup trigger.
1001
Uses ADTG_8 at the input pin of ADC unit 0’s startup trigger.
Writing other data
Setting is prohibited.
[bit11:10] QZIN1S: QZIN1S Input Select bits
Selects input for QPRC ZIN1.
bit11:10
Description
Reading
Reads out the register value.
Writing
00
Uses ZIN1_0 at the input pin of QPRC ch.1’s ZIN. [Initial value]
01
Same as Writing 00.
10
Uses ZIN1_1 at the input pin of QPRC ch.1’s ZIN.
11
Uses ZIN1_2 at the input pin of QPRC ch.1’s ZIN.
[bit9:8] QBIN1S: QBIN1S Input Select bits
Selects input for QPRC BIN1.
bit
Description
Reading
Reads out the register value.
Writing
00
Uses BIN1_0 at the input pin of QPRC ch.1’s BIN. [Initial value]
01
Same as Writing 00.
10
Uses BIN1_1 at the input pin of QPRC ch.1’s BIN.
11
Uses BIN1_2 at the input pin of QPRC ch.1’s BIN.