Cypress FM4 Series - Page 844

CHAPTER 15: SD Card Interface
844 FM4 Peripheral Manual, Doc. No. 002-04856 Rev. *E
Register Name
Reference
Power Switching Interrupt Status Enable Register
2.40
Power Switching Interrupt Signal Enable Register
2.41
MMC/eSD Control Register
2.42
MMC Wait IRQ Control Register
2.43
MMC Wait IRQ Control Register
2.44
MMC Response Check Bit Register
2.45
Card Detect Setting Register
2.46
The addresses 0x000 to 0x0FF is the Standard Register defined in SD Specifications Part A2.
Notes:
− The write access to a reserved area is prohibited.
− The attributes of the registers of the SD card interface use the register attributes defined in SD
Specifications Part A2. For the respective meanings of the register attributes, refer to SD
Specifications Part A2.