Siemens SCALANCE W760 - Show Sntp Status; Show Sntp Unicast-Mode Status

System time
5.3 SNTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
110 Configuration Manual, 11/2014, C79000-G8976-C351-03
Result
The current SNTP broadcast configuration is displayed.
5.3.2
show sntp status
Description
This command shows the settings of the Simple Network Time Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp status
Result
The settings of SNTP are displayed.
5.3.3
show sntp unicast-mode status
Description
This command shows the current configuration of the unicast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp unicast-mode status