Siemens SCALANCE W760 Configuration Manual

Network protocols
7.9 SSH server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
341
Syntax
Call up the command with the following parameters:
show ip arp [{Vlan<vlan-id(1-4094)>|<interface-type><interface-id>|
<ip-address>|<mac-address>|summary|information}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
ip-address
Shows the IP addresses of the entries
in the ARP table
-
mac-address
Shows the MAC addresses of the en-
tries in the ARP table
-
summary
Shows a summary of the entries in the
ARP table
-
information
Displays information on the ARP con-
figuration
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If you do not select any parameter from the parameter list, the IP ARP table is displayed.
Result
The IP ARP table is displayed.
7.9
SSH server
This section describes commands of the Secure Shell (SSH) Server.

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English