Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
178 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
wlan hw-retries <1-60>
The parameter has the following meaning:
Values or range of values
Number of retries 1 ... 60
The number of retries is specified.
You display the setting with the show wlan advanced <wlan 0/X> command.
wlan max tx-power
Description
With this command, you specify the transmit power of the device. It may be necessary to
reduce the transmit power when using antennas to avoid exceeding the maximum legal
transmit power. Reducing the transmit power effectively reduces cell size.
Note
The maximum possible transmit power varies depending on the channel and data rate. For
more detailed information on transmi
t power, refer to the documentation "Characteristics
Using the show wlan basic command, check whether or not the current WLAN settings
violate the permitted transmit power restrictions (
TX Power Check) of the selected country.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
To Next Page
Loading...
Need help?
General
