Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
296 Configuration Manual, 11/2014, C79000-G8976-C351-03
You configure the DHCP option 67 with the option value-string command.
You configure the DHCP options 3, 6 and 66 with the
option command.
You configure all other DHCP options with the
option value-hex command.
available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command you specify that this IPv4 address band will be used.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call the command without parameter assignment:
pool-enable
The setting is enabled.
Note
If the IPv4 address band is activated, no DHCP options (option
...) and static assignments
(static leases) can be configured.
You display the setting with the show ip dhcp-server pools command.
You disable the setting with the
no pool-enable command.
To Next Page
Loading...
Need help?
General
