Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
385
no wlan security encryption (client)
Description
With this command, you disable encryption with a fixed (unchanging) WEP key. This setting
is activated as default. You can only enable or disable encryption if you have selected "Open
System" for authentication.
Note
This command is only available in the client mode.
● The type of authentication is "open-system".
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
no wlan security encryption
The encryption is disabled.
You display the settings with the show wlan security <wlan 0/X> command.
You enable the encryption with the
wlan security encryption command.
wlan security encryption (client) (Page 384)
wlan security authentication (client) (Page 374)
To Next Page
Loading...
Need help?
General
