Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
71
Call up the command with the following parameters:
tftp server {<ipv4-addr>}[port<tcp port(1-65535)>]
The parameters have the following meaning:
Identifies the unicast IPv4 address
Enter a valid unicast IPv4 address
Keyword for the port of the server via
which the TFTP connection runs
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The settings for the access to the selected TFTP server are configured.
With this command, you activate and configure the password for the user certificate.
Note
This command is only available in
the client mode
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
To Next Page
Loading...
Need help?
General
