Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
192 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.1.7
Commands in the WDS Interface Configuration mode
This section describes commands that you can call up in the WDS Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
interface wdsX 0/Y command to change to this
mode.
● If you exit the WDS Interface Configuration mode with the
exit command, you return to
the Global Configuration mode.
● If you exit the WDS Interface Configuration mode with the
end command, you return to the
Privileged EXEC mode.
6.1.7.1
wds partner id-type (access point)
Description
With this command, you specify whether the WDS partner is detected by the access point by
the MAC address or the WDS ID.
Note
This command is available only i
n access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds partner id-type { mac-address | wds-id }
The parameters have the following meaning:
Parameters
Description
mac-address
The MAC address is used for communication. With the "wds partner mac"
command, you specify the MAC address.
wds-id
The WDS ID is used for communication. With the "wds partner wds id" com-
mand, you specify the WDS ID.
Result
The type of communication is specified.

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English