Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
146 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.1.5.6
no wlan ampdu
Description
With this command, you disable the sending of AMPDU data packets. If the function is
disabled, only AMPDU data packets can be received.
Requirement
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan ampdu
Result
The sending of AMPDU data packets is disabled.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You enable the function with the
wlan ampdu command (default setting).
See also
wlan ampdu (Page 145)
6.1.5.7
wlan ampdu bytes-limit
Description
With this command, you specify the maximum size of the AMPDU data packet in bytes.
Note
This command is
available only in access point mode.

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English