Functions specific to SCALANCE
4.4 iPCF-MC
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
95
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameter assignment:
show wlan ipcf-mc
The iPCF_MC settings are displayed.
Commands in the WLAN configuration mode
This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the
wlan command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can
be found in the relevant sections.
● If you exit the WLAN configuration mode with the
exitcommand, you return to the Global
configuration mode.
● If you exit the WLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command, you enable iPCF-MC on this device.
To Next Page
Loading...
Need help?
General
