Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
282 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
show ip dhcp-server pools [pool-id (1-5)]
The parameter has the following meaning:
ID of the addressed IPv4 address
band
1 ... 5
Only ID = 1 is supported.
The configuration of the DHCP server and the DHCP options is displayed.
show ip dhcp-server bindings
command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
This command shows the current assignments of IPv4 addresses of the DHCP server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameter assignment:
show ip dhcp-server bindings
The information is displayed.
To Next Page
Loading...
Need help?
General
