Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
197
The entries are displayed.
show mac-address-table
Description
This command shows the table with the static and dynamic unicast MAC addresses and
multicast MAC addresses.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show mac-address-table [vlan<vlan-range>][address<aa:aa:aa:aa:aa:aa>]
[interface <interface-type><interface-id>]
The parameters have the following meaning:
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
1 ... 4094
Keyword for a MAC address
Keyword for a an interface description
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
The entries of the MAC addresses table are displayed.
To Next Page
Loading...
Need help?
General
