Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
183
no wlan outdoor
Description
With this command, you disable the outdoor mode or enable the indoor mode. This setting is
activated as default.
In indoor mode, all the country-dependent permitted channels and transmit power settings
are available for operation in a building.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
no wlan outdoor
The indoor mode is enabled or the outdoor mode is disabled.
You display the setting with the show wlan basic <wlan 0/X> command.
You enable the outdoor mode with the
wlan outdoor command.
wlan outdoor (Page 182)
wlan overlap-ap aging (access point)
Description
With this command, you configure the aging time for the list of overlapping access points. If
an access point is inactive for longer than the set time, it is removed from the list.
Note
This command is available only in access point
mode.
To Next Page
Loading...
Need help?
General
