Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
260 Configuration Manual, 11/2014, C79000-G8976-C351-03
The overview of the DCP forwarding behavior is displayed.
show dcp server
Description
This command shows whether or not the DCP function is enabled on the device.
If the DCP function is enabled, the read and write permissions are displayed.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show dcp server
The overview of the status of the DCP function and access rights is displayed.
show ip route
Description
This command shows the routes currently being used.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|static}]
To Next Page
Loading...
Need help?
General
