Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
271
ip name-server
Description
This command specifies an IP address of a DNS server. If there is more than one server,
you can specify the order in which the servers are queried. To allow this, the optional
parameter
index is available. The server with the lowest index is queried first.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
ip name-server ipv4 <ucast_addr> [index <id(1-3)>]
The parameters have the following meaning:
IP address of the DNS server Enter a valid IP address
Index of the DNS server 1 ... 3
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The IP address and, if specified, the index for a DNS server has been set.
To Next Page
Loading...
Need help?
General
