Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
209
The Interface is added to the VLAN as an untagged port and the corresponding VLAN ID is
set.
You can reset the setting to the default with the no switchport access vlan command.
You display the setting and other information with the
show vlan port config command.
no switchport access vlan
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no switchport access vlan
The setting is reset to the default value.
You configure the setting with the switchport access vlan command.
You can display the status of this function and other information with the
show vlan port
config
command.
To Next Page
Loading...
Need help?
General
