Siemens SCALANCE W760 - Wlan Frequency Band (Client)

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
174 Configuration Manual, 11/2014, C79000-G8976-C351-03
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan frequency band { 2.4 | 5 }
The parameters have the following meaning:
Parameter
Description
Default setting
2.4
Frequency band 2.4 GHz
WLAN1: 2.4 GHz
5
Frequency band 5.2 (4.9; 5.6; 5.8) GHz
Result
The frequency band for the WLAN interface is specified.
Further notes
You display the setting with the show wlan basic <wlan 0/X> command.
6.1.5.38
wlan frequency band (client)
Description
With this command, you specify the frequency band for the WLAN interface.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#