Siemens SCALANCE W760 - No Vlan; Base Bridge-Mode

Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
205
6.2.2.4
no vlan
Description
With this command, you delete a VLAN on the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameter:
no vlan <vlan-id(2-4094)>
Parameter
Description
Range of values / note
vlan-id
Number of the addressed VLAN
2 ... 4094
The VLAN with number 1 cannot be deleted.
Result
The VLAN is deleted
Further notes
With the vlan command, you create a VLAN on the device.
You can display information about the VLAN with the
show vlan command.
6.2.2.5
base bridge-mode
Description
With this command, you configure whether or not the device is configured as a bridge
according to IEEE 802.1D for the Spanning Tree protocol or according to IEEE 802.1Q for a
virtual bridged LAN.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#