Siemens SCALANCE W760 - Wlan Antenna Gain-2-4 Ghz; Wlan Antenna Gain-5 Ghz

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
150 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.1.5.11
wlan antenna gain-2-4GHz
Description
With this command, you specify the antenna gain of the antenna type "User defined" in the
2.4 GHz frequency band. With the
show wlan basic command, check whether the maximum
transmit power is exceeded with the setting.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna gain-2-4GHz <index(1)> <dBi(0-30)>
The parameters have the following meaning:
Parameter
Description
Values or range of values
index
Antenna connector
1
gain value
Antenna gain in decibels isotropic (dBi) 0 ... 30
0 = antenna is not connected
Result
The antenna gain is specified.
Further notes
You show the set antenna gain with the show wlan antennas <wlan 0/X> command.
6.1.5.12
wlan antenna gain-5GHz
Description
With this command, you specify the antenna gain of the antenna type "User defined" in the 5
GHz frequency band. With the
show wlan basic command, check whether the maximum
transmit power is exceeded with the setting.