Siemens SCALANCE W760 Configuration Manual

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
319
Further notes
You delete the details of an SNMP group with the no snmp notify command.
You display the configured SNMP notifications with the
show snmp notif command.
You display the configured SNMP target addresses with the
show snmp targetaddr
command.
7.4.2.13
no snmp notify
Description
With this command, you delete the details of the SNMP notifications.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp notify <NotifyName>
The parameters have the following meaning:
Parameter
Description
Range of values / note
NotifyName
Name of the notification
max. 32 characters
Result
The details of the SNMP notifications are deleted.
Further notes
You change the details of an SNMP group with the snmp notify command.
You display the configured SNMP notifications with the
show snmp notif command.
You display the configured SNMP target addresses with the
show snmp targetaddr
command.

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English