Siemens SCALANCE W760 - No Static-Lease

Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
300 Configuration Manual, 11/2014, C79000-G8976-C351-03
7.3.4.11
no static-lease
Note
The command is only available when the following requirements are met:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
•
The IPv4 address band is not enabled.
Description
With this command, you delete the assignment of an IPv4 address to a MAC address.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no static lease mac <mac-address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
mac-address
Unicast MAC address
Specify a valid MAC address.
Result
The assignment is deleted.
Further notes
You configure the assignment with the static-lease mac command.