Siemens SCALANCE W760 Configuration Manual

Network protocols
7.2 DHCP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
280 Configuration Manual, 11/2014, C79000-G8976-C351-03
7.2.4.2
no ip dhcp config-file-request
Description
With this command, you disable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip dhcp config-file-request
Result
The DHCP config file request option is disabled.
Further notes
You enable the DHCP config file request option with the ip dhcp config-file-request
command.
7.2.4.3
ip dhcp client mode
Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname}

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English