Siemens SCALANCE W760 Configuration Manual

Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
272 Configuration Manual, 11/2014, C79000-G8976-C351-03
7.1.2.12
no ip name server
Description
This command deletes the entry with the specified index for a DNS server. If you do not
specify an index, all entries are deleted.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip name-server [index <id(1-3)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
index
Keyword for the index
-
id
Index of the DNS server 1 ... 3
Result
The specified entries for the DNS servers were deleted.
7.1.2.13
ip domain used server
Description
This command specifies which DNS server the device uses.
Note
Only resource records of type A (IPv4 address of a host) are supported.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English